I recently purchased a 1 Farad Capacitor with installation tools and have no idea how to install it?

2 Responses to “I recently purchased a 1 Farad Capacitor with installation tools and have no idea how to install it?”

1. M.B. says:

   May 22, 2010 at 3:28 pm

   Caps are easy to install. I’m assuming your amp is already hooked up correctly.

   1) Take the power lead from the amp out, connect it to the Positive terminal on the cap.

   2) Add a power wire from the positive terminal on the cap to the positive terminal on the amp.

   3) Make a ground wire from the cap to a good ground point. It can be the same place your amp is grounded.

   Done.

   The only reason you would use the D block is if you have multiple amps. In that case place the D block after the cap, with power wires from the D block to each amp.
2. syco noodles says:

   May 22, 2010 at 3:28 pm

   i have got a few questions for you first

   how many amps have you got?
   how much rms are they pumping out?

   if you have ansered 3 amps or less (you wont need a cap)
   if the amps are pumping out under 2000w rms (you wont need a cap)

Leave a Reply

Click here to cancel reply.

Name (required)

Mail (will not be published) (required)

Website

CAPTCHA Code *